128GB MyDigitalSSD BP3 Bullet Proof 3 mSATA III (6Gbps) Solid State Disk by MyDigitalSSD

The cost efficient high speed mSATA upgrade you've been looking for is here with the reliability you've come to expect from MyDigitalSSD Bullet Proof SSDs.

Introducing MyDigitalSSD Bullet Proof 3 (BP3) 50mm mSATA III solid state drives for Notebooks, Ultrabooks, Tablets, and Desktop computers. BP3 drives are easy to install SSD upgrades that eliminate the bottle-neck of stock hard drives (HDDs) and double the performance of SATA II SSDs with speed boosts that not only increase productivity but lower energy consumption, prolonging battery life.

Backwards compatible with SATA II applications, BP3 drives will peg SATA II BUS speeds in most cases.

About the Controller

MyDigitalSSD BP3 SSDs feature the Phison S-Module III S8 controller to deliver all the advantages of Flash Disk technology with the Serial ATA III interface, fully compliant with standard mSATA form factor. The S-Module III S8 is based on the mSATA form factor which is generated by JEDEC, designed to operate at a maximum operating frequency of 300MHz with 40MHz external crystal. Its capacity could provide a wide range up to 256GB. Also it can reach 500MB/s throughput based on ONFI/Toggle NAND (with DDR3 cache enabled and measured by CrystalDiskMark). Also the power consumption of mSATA module is much lower than traditional Hard Drive.

Highlights

- Unequaled price to performance ratio
- 24nm Toshiba HBL Flash
- Large storage capacity
- Easy remove and replace installation
- SATA Revision 3.0 compliant: High-speed SATA 6Gb/s interface
- Compatible with SATA 1.5G/s, 3Gb/s interface
- Support DDR3 I/O interface
- Power management supported
- NCQ command set
- TRIM support
- RAID support
- Three year replacement warranty

Features

- High and Reliable ECC capability up to 24bits/sector
- Bit error monitoring and management
- Dynamic and static wear-leveling
- Dynamic bad block management
- ONFI2.0 and Toggle2 Interface support
- Supports 1.8V and 3.3V voltage level
- - Supports 1.8V for ONFI Flash
- - Supports 3.3V for conventional Asynchronous Flash
- DDR3 Interface
- - 16 bit data bus
- - Clock Rate: 480MHz

Compatibility:

ASUS Eee Slate EP121
Dell Precision M4500, M4600, M6400, M6500
Fusion Garage JOOJOO
Google CR-48 Chrome
HP Envy 14 Beats
Lenovo K26, K47A, K47G
Lenovo IdeaPad Y460, Y470, Y560, Y570
Lenovo ThinkPad T420S, T420, T520, L420, L520, W520, X220
Lenovo ThinkPad Edge E220s, E320, E420s
Samsung Series 9
WeTab
And many more devices. Please check manufacturer handbook for information.


Note: Solid State Drives DO NOT require defragmentation. It may decrease the lifespan of the drive.

• 1 review